Sign up Latest Topics Donate
 
 
 


Reply
  Author   Comment  
crazeehorse

Apprentice
Registered:
Posts: 1
Reply with quote  #1 
005.JPG  006.JPG  I would like to get suggestions on how to join this section of rubber roof to a metal roof above it & also build a flashing to the brick where the flat roof meets it. Any help would be most appreciated.
0
Roofing HatchetMAN

Elite Roofer - Platinum Member
Registered:
Posts: 91
Reply with quote  #2 
Wow!  It needs a lot of help for sure.

Personally I wouldn't have just terminated the epdm rubber roof with t-bar just below the screw down metal roof.

I would have made the rubber run underneath the metal roof....even if that meant unscrewing the panels to 
get it up under.

Are you in the Northern Climate?  Was this done by a contractor or just by yourself?

Thanks for the post.  We'll do our best to help. [smile]
0
bwindustries

Journeyman
Registered:
Posts: 7
Reply with quote  #3 
However if you plan your roof and give it just a little thought first, then prepare carefully and spend a little bit extra on some nice EPDM roof trims, not only will you have a superb hard wearing new roof but one that will actually look nice too.
steel purlins
0
Texas Roofer

Master Roofer
Registered:
Posts: 24
Reply with quote  #4 
If this is still a problem give me a call, 940-500-0303 be easier to talk to you about it than type it. you have a few things to address.
0
campbelldiana742

Journeyman
Registered:
Posts: 9
Reply with quote  #5 
Apply Termination Tape to connect the wall and roof tapes
__________________
Contractor Quotes
0
Previous Topic | Next Topic
Print
Reply

Quick Navigation:

Easily create a Forum Website with Website Toolbox.